U1872 BMW Fault Code
Check U1872 OBD Fault Code ReasonThrottle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden BMW TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the BMW PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.
U1872 Code Symptoms :
When you turn on the ignition, the Service Engine Soon or Check Engine U1872 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the U1872!
Diagnosis And Repairing U1872
U1872 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.
How to fix U1872 code ?
- Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
- Faulty Fuel injector
- Intake Valve Timing Control Solenoid Valve harness is open or shorted
To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.
Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.